At least on my machine it is solved.
I had trouble big time getting CAM up and running on my computer.
I got a lot of error messages during boot. (These messages have been
discussed previously on the lists, so I will not repeat them here)
My problem was solved by replacing the motherboard/CPU.
My previous setup was as follows:
Adaptec 2940U2W host adapter
Seagate Cheetah ST34502LW U2W drive
Seagate Barracuda ST34573LW U2W drive
Pioneer DR-U06S CDROM drive
Spacewalker.603 MB (AMD 640-based)
Cyrix 6x86MX-PR200 CPU (Clocked as 2x66 - PR166)
When swapping the MB and CPU for an AOpen AP5T (430TX-based) with a
P55C-200MHz the problems disappeared.
Just a note to the other people out there with similar problems. Try
swapping around a bit with MB and CPU. Maybe it works.
To Unsubscribe: send mail to majo...@FreeBSD.org
with "unsubscribe freebsd-scsi" in the body of the message
1 message in org.freebsd.freebsd-scsiAHC CAM problems solved