Thank you for the response... I didn't see this being possible but somewhere
someone had told me you could run it that way.... only way I could see is
3.2Mhz width with Docsis 2.0 being backwards compatible ... thanks again for
the confirmation...
Paul
-----Original Message-----
From: Michel Renfer [mailto:mich...@finecom.ch]
Sent: Monday, March 05, 2007 10:39 AM
To: cisco-nsp at puck.nether.net
Cc: Paul Stewart
Subject: RE: [c-nsp] Ubr Docsis 2.0 Question
Hi Paul
No, of course not. Your DOCSIS 1.x (TDMA) modems will only support
channel-widths up to 3.2 MHz. If you want use the benefits of a 6.4 MHz
channel-width you need to use DOCSIS 2.0 modems (ATDMA).
cheers,
michel
-----Original Message-----
From: cisco-nsp-bounces at puck.nether.net [mailto:cisco-nsp-
bounces at puck.nether.net] On Behalf Of Paul Stewart
Sent: Monday, March 05, 2007 4:02 PM
To: cisco-nsp at puck.nether.net
Subject: [c-nsp] Ubr Docsis 2.0 Question
Hi there...
I'm pretty sure there's some Ubr experts on here ;)
We are migrating a Cisco Ubr7114 up to Ubr7246VXR - so during this
we'll be changing to Docsis 2.0 ... this will also involve changing
the channel bandwidth from 3.2 to 6.4 Mhz....
My question is in regards to Docsis1.1 modems - if we change the
channel size to 6.4 is there a way to support modems that only work
with 3.2 channel width (therefore Docsis 1.x)??
Thanks in advance,
7 messages in net.nether.puck.cisco-nsp[c-nsp] Ubr Docsis 2.0 Question
