4 messages in com.googlegroups.sketchupissuesRe: Trouble with Follow Me| From | Sent On | Attachments |
|---|---|---|
| Kermit | 27 Feb 2008 05:47 | |
| Jean (Johnny) Lemire | 27 Feb 2008 07:08 | |
| Kermit | 27 Feb 2008 08:22 | |
| Kermit | 27 Feb 2008 08:32 |
| Subject: | Re: Trouble with Follow Me |
|---|---|
| From: | Kermit (etwe...@vianet.ca) |
| Date: | 02/27/2008 08:32:41 AM |
| List: | com.googlegroups.sketchupissues |
Somthing else I just discovered; I can create the same problem by asking for too many sides on either circle.
Kermit, from Etwell, Ontario.
On Feb 27, 11:22 am, Kermit <etwe...@vianet.ca> wrote:
Thank You! It is definatly size related. I was creating a wire loop, as part of another model, which was a .625" loop of.0313" diameter wire. The Programe would not accept this small radius to create the circle, so I changed it to .04" and it accepted this, but I then ran into the priblem I described. On Your suggestion I tried increaseing the radius just .001" at a time. At (radius) .024" I got the outside half of the hoop, at ,025" I got the hoop (donut). So I will scale the model up; I can deal with that. Thanks, I got really stuck on that.
Kermit, from Etwell, Ontario.
On Feb 27, 10:09 am, "Jean (Johnny) Lemire" <jean...@tecsult.com> wrote:
Hi Kermit, hi folks.
It sould work unless your model is so small that SU cannot close any face. Any edge smaller than 1 mm or about 1/16 inch will prevent a face from closing.
Can you post your model ?
Just ideas.
Jean (Johnny) Lemire from Richelieu, Quebec, Canada.- Hide quoted text -