10 messages in org.freebsd.freebsd-hackersRoute/arp help?| From | Sent On | Attachments |
|---|---|---|
| M. Parsons | Apr 13, 2005 10:43 am | |
| Iasen Kostov | Apr 13, 2005 1:12 pm | |
| M. Parsons | Apr 13, 2005 1:38 pm | |
| Iasen Kostov | Apr 13, 2005 1:57 pm | |
| M. Parsons | Apr 13, 2005 2:33 pm | |
| Steve Watt | Apr 13, 2005 4:38 pm | |
| M. Parsons | Apr 13, 2005 5:31 pm | |
| Stephan Uphoff | Apr 13, 2005 5:49 pm | |
| Neo-Vortex | Apr 14, 2005 5:28 am | |
| M. Parsons | Apr 14, 2005 7:49 am |
| Subject: | Route/arp help? | |
|---|---|---|
| From: | Neo-Vortex (ro...@Neo-Vortex.net) | |
| Date: | Apr 14, 2005 5:28:19 am | |
| List: | org.freebsd.freebsd-hackers | |
On Wed, 2005-04-13 at 16:38, M. Parsons wrote:
I was under the impression (but would need to check to make sure) that all incoming packets are diverted to ng_pppoe when it is hooked into the Ethernet interface.
This would explain your problems.
Can you try this without the interface being used for PPPOE?
I have a single interface for PPPoE using netgraph and it connects to the modem, and other computers fine
For the record, http://www.broadbandreports.com/faq/9693 is the page on how you access the line stats, and the MAC part is required for my modem.
The only reason i could think of as to why it is required, is if its ip address isn't 10.0.0.1 as you think it is and for some strange reason it accepts ip packets as its own if the ethernet header points to its MAC address... try setting it to DHCP and see if you get an ip... else look up the manufacturer for the default ip and try a factory reset