 | Start a set with this search |
 | Include this search in one of my sets |
 | Exclude this search from one of my sets |
 | Permalink to these results Paste this link in email or IM: |
 | Atom feed for tracking future search results Paste this URL into your reader: |
9 messages in net.nether.puck.cisco-nsp[c-nsp] RPR+ on Cisco 7513| From | Sent On | Attachments |
|---|---|---|
| Dan Benson | Jan 21, 2005 3:49 pm | |
| Rodney Dunn | Jan 21, 2005 4:15 pm | |
| Pete Templin | Jan 21, 2005 7:56 pm | |
| Dan Benson | Jan 25, 2005 10:20 am | |
| Rodney Dunn | Jan 25, 2005 10:29 am | |
| Dan Benson | Jan 25, 2005 11:10 am | |
| Rodney Dunn | Jan 25, 2005 1:17 pm | |
| Jon Lewis | Jan 25, 2005 2:32 pm | |
| Rodney Dunn | Jan 25, 2005 2:51 pm |
| Permalink for this message Paste this link in email or IM: |
| Permalink for this thread Paste this link in email or IM: |
| Atom feed for this thread Paste this URL into your reader: |
| Subject: | [c-nsp] RPR+ on Cisco 7513 | Actions... |
|---|---|---|
| From: | Rodney Dunn (rod...@cisco.com) | |
| Date: | Jan 25, 2005 1:17:44 pm | |
| List: | net.nether.puck.cisco-nsp | |
Since it's in the lab can you try a couple things:
a) Take out the VIP2-50 b) How much memory is on the 4-50's? c) What does: sh cef linecard say?
d) Turn CEF back on for Fas2/0/0. You have turned it off:
interface FastEthernet2/0/0 ip address 10.0.6.53 255.255.255.0 no ip directed-broadcast no ip route-cache cef no ip route-cache distributed no ip route-cache
I don't think this has anything to do with it but can you move the disk to disk1: for the RSP in slot 7 just so they are the same.
Then capture:
sh run sh redund sh cef linecard
Do the force switchover and capture the console output from both RSP's.
After it's cut over get: sh redund sh redund history
If you can get me console access to the RSP's I can look at it with you.
Rodney
On Tue, Jan 25, 2005 at 11:10:47AM -0500, Dan Benson wrote:
Here is the config, show DIAG and VER. Thanks again for the insight.. //db
Building configuration...
Current configuration : 1363 bytes ! version 12.0 no service pad service timestamps debug uptime service timestamps log uptime no service password-encryption service single-slot-reload-enable ! hostname Router ! boot-start-marker boot system flash disk1:rsp-k4pv-mz.120-27.S4.bin boot-end-marker ! redundancy no keepalive-enable mode sso logging snmp-authfail
! ip subnet-zero ip cef distributed ip ssh time-out 120 ip ssh authentication-retries 3 hw-module slot 6 image disk1:rsp-k4pv-mz.120-27.S4.bin hw-module slot 7 image disk0:rsp-k4pv-mz.120-27.S4.bin ! ! ! interface GigabitEthernet0/0/0 no ip address no ip directed-broadcast load-interval 30 negotiation auto ! interface FastEthernet1/0/0 no ip address no ip directed-broadcast shutdown ! interface FastEthernet2/0/0 ip address 10.0.6.53 255.255.255.0 no ip directed-broadcast no ip route-cache cef no ip route-cache distributed no ip route-cache ! interface Hssi3/0/0 no ip address no ip directed-broadcast shutdown ! interface Hssi3/0/1 no ip address no ip directed-broadcast shutdown ! interface ATM4/0/0 no ip address no ip directed-broadcast shutdown no atm enable-ilmi-trap no atm ilmi-keepalive ! ip default-gateway 10.0.6.1 ip classless ! ! ! ! line con 0 line aux 0 line vty 0 4 exec-timeout 0 0 password gnaps123 login length 0 ! no cns aaa enable end
Router# sho redundancy Redundant System Information :
------------------------------ Available system uptime = 28 minutes Switchovers system experienced = 0 Standby failures = 0 Last switchover reason = none
Hardware Mode = Duplex Configured Redundancy Mode = sso Operating Redundancy Mode = sso Maintenance Mode = Disabled Communications = Up
Current Processor Information :
------------------------------- Active Location = slot 6 Current Software state = ACTIVE Uptime in current state = 27 minutes Image Version = Cisco Internetwork Operating System Software IOS (tm) RSP Software (RSP-K4PV-M), Version 12.0(27)S4, RELEASE SOFTWARE (fc1) Technical Support: http://www.cisco.com/techsupport Copyright (c) 1986-2004 by cisco Systems, Inc. Compiled Tue 21-Dec-04 17:56 by pwade BOOT = disk1:rsp-k4pv-mz.120-27.S4.bin,1; Configuration register = 0x2102
Peer Processor Information :
---------------------------- Standby Location = slot 7 Current Software state = STANDBY HOT Uptime in current state = 0 minutes Image Version = Cisco Internetwork Operating System Software IOS (tm) RSP Software (RSP-K4PV-M), Version 12.0(27)S4, RELEASE SOFTWARE (fc1) Technical Support: http://www.cisco.com/techsupport Copyright (c) 1986-2004 by cisco Systems, Inc. Compiled Tue 21-Dec-04 17:56 by pwade BOOT = disk1:rsp-k4pv-mz.120-27.S4.bin,1; CONFIG_FILE = BOOTLDR = Configuration register = 0x2102 *
*Router#sho diagbus 6 Slot 6: EEPROM format version 1 Route/Switch Processor 4, FRU: RSP4+=, HW rev 1.06, board revision A0 Serial number: 21016486 Part number: 73-5512-02 Test history: 0x14 RMA number: 00-00-00 Flags: cisco 7000 board; 7500 compatible
EEPROM contents (hex): 0x20: 01 1A 01 06 01 40 AF A6 49 15 88 02 14 00 00 00 0x30: 50 FF FF 02 00 00 00 00 00 00 00 00 00 00 00 00 Router#sho diagbus 7 Slot 7: EEPROM format version 1 Route/Switch Processor 4, FRU: RSP4+=, HW rev 1.06, board revision A0 Serial number: 28443840 Part number: 73-5512-02 Test history: 0x00 RMA number: 00-00-00 Flags: cisco 7000 board; 7500 compatible
EEPROM contents (hex): 0x20: 01 1A 01 06 01 B2 04 C0 49 15 88 02 00 00 00 00 0x30: 50 00 00 02 00 00 00 00 00 00 00 00 00 00 00 00 Router#
Router#sho ver Cisco Internetwork Operating System Software IOS (tm) RSP Software (RSP-K4PV-M), Version 12.0(27)S4, RELEASE SOFTWARE (fc1) Technical Support: http://www.cisco.com/techsupport Copyright (c) 1986-2004 by cisco Systems, Inc. Compiled Tue 21-Dec-04 17:56 by pwade Image text-base: 0x40010EA4, data-base: 0x413E8000
ROM: System Bootstrap, Version 12.0(10r)S1, RELEASE SOFTWARE (fc1) BOOTLDR: RSP Software (RSP-K4PV-M), Version 12.0(27)S4, RELEASE SOFTWARE (fc1)
Router uptime is 30 minutes System returned to ROM by reload at 15:30:10 UTC Tue Jan 25 2005 System image file is "disk1:rsp-k4pv-mz.120-27.S4.bin"
cisco RSP4+ (R5000) processor with 262144K/2072K bytes of memory. R5000 CPU at 200Mhz, Implementation 35, Rev 2.1, 512KB L2 Cache Last reset from power-on G.703/E1 software, Version 1.0. G.703/JT2 software, Version 1.0. X.25 software, Version 3.0.0. Chassis Interface. 1 VIP2 controller (1 FastEthernet). 4 VIP4-50 RM5271 controllers (1 FastEthernet)(1 GigabitEthernet)(2 HSSI)(1 ATM). 2 FastEthernet/IEEE 802.3 interface(s) 1 GigabitEthernet/IEEE 802.3 interface(s) 2 HSSI network interface(s) 1 ATM network interface(s) 123K bytes of non-volatile configuration memory.
107520K bytes of ATA PCMCIA card at slot 1 (Sector size 512 bytes). 16384K bytes of Flash internal SIMM (Sector size 256K).
Slave in slot 7 is running Cisco Internetwork Operating System Software IOS (tm) RSP Software (RSP-K4PV-M), Version 12.0(27)S4, RELEASE SOFTWARE (fc1) Technical Support: http://www.cisco.com/techsupport Copyright (c) 1986-2004 by cisco Systems, Inc. Compiled Tue 21-Dec-04 17:56 by pwade Slave: Loaded from system Slave: cisco RSP4+ (R5000) processor with 262144K bytes of memory.
Configuration register is 0x2102