Is it HEC or PLCP? You may want to try changing between the two on the
main ATM interface (atm framing cbitplcp/etc)
-Dave
On Thu, 20 Jan 2005, Voll, Scott wrote:
Router1#sh controllers atm
ATM4/0/0: Port adaptor specific information
Hardware is DS3 (45000Kbps) port adaptor
Framer is PMC PM7345 S/UNI-PDH, SAR is LSI ATMIZER II
Firmware rev: G152, ATMIZER II rev: 3
Framing mode: DS3 C-bit ADM
Default Maximum Queue Length: 0
Facility alarm: OOF LossOfCellDelineation
Facility statistics: current interval elapsed 524 seconds
-----Original Message-----
Can anyone give me a hit as to what I'm doing wrong?
I'm trying to bring up an ATM DS3 and I'm getting Rx loss.
My config is below. Am I missing more configurations?
interface ATM4/0/0
no ip address
!
!
interface ATM4/0/0.33 point-to-point
description XXXXXX
ip address xxx.xxx.xxx.xxx 255.255.255.252
pvc 1/33
vbr-nrt 1024 1024
encapsulation aal5snap
This is a FR to ATM configuration using a CAT 6509 flexwan / ATM DS3
Card (enhanced).
Telco is pointing finger my way. Do I need to setup Controller in
global config?
TIA
13 messages in net.nether.puck.cisco-nsp[c-nsp] Trying to get an ATM ciruit up
