On Jan 14, 2005, at 8:36 AM, Rodney Dunn wrote:
Noel, Tom,
There are limitations on the 75xx's depending on the
RSP/VIP setup you have.
It's a distributed platform that does software
based forwarding when running in dCEF mode.
All packet are switched by the VIPs and never
touch the RP. Therefore the switching capacity
is a function of the speed of the VIPs and the
features you have enabled in the packet path
(ACL's, QOS, etc..).
Doesn't the RP handle the timing on the CyBus (1.2 gbps) and doesn't it
touch the packet when it travels between VIPs on different CyBUSes
(7513 has 2)? Bus arbitration is done on the RP ?? The 7500 doesn't
have CSC card like the 12k series
The short answer is there isn't a bandwidth concept
like there is with the 72xx. However, you can
overload the VIP with the right PA combination and
features. The matrix of performance will depend on
the features, ppps, and VIP type.
There have been extensive discussions
about this on cisco-nsp so if there are further questions
I'd suggest we move it over there and I can add more.
Thanks,
Rodney
On Thu, Jan 13, 2005 at 09:09:28PM -0500, Noel Montales wrote:
On-List replies perhaps may be usefull.. Or could you post a summary
of
your findings?
Regards,
Noel Montales
Claydon, Tom said:
Hello,
We are moving from a Cisco 7206 to a 7513, and I was wondering if we
will be limited by bandwidth points on the 7513 (as we are with the
7206). From the sparse documentation I've found so far, it doesn't
appear that this limitation exists in the 7513, correct?
Off-list replies are welcomed.
6 messages in net.nether.puck.cisco-nsp[c-nsp] Re: Cisco 7513 & Bandwidth Po...
